당신은 온라인 연습 문제를 통해 DELL EMC D-NWG-FN-23 시험지식에 대해 자신이 어떻게 알고 있는지 파악한 후 시험 참가 신청 여부를 결정할 수 있다.
시험을 100% 합격하고 시험 준비 시간을 35% 절약하기를 바라며 D-NWG-FN-23 덤프 (최신 실제 시험 문제)를 사용 선택하여 현재 최신 221개의 시험 문제와 답을 포함하십시오.
/ 6
Question No : 1
What accurately describes the comparison between stacking and VLT?
정답:
Question No : 2
What accurately describes the Network Time Protocol (NTP)?
정답:
Question No : 3
What is administrative distance value for default static routes?
정답:
Question No : 4
Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?
정답:
Question No : 5
Refer to the output:
console#show interfaces switchport te1/0/1 Port: Te1/0/1
VLAN Membership Mode: General Mode Access Mode VLAN: 1 (default)
General Mode PVID: 9 General Mode Ingress Filtering: Enabled General Mode
Acceptable Frame Type: Admit All
General Mode Dynamically Added VLANs: General Mode Untagged VLANs: 1, 9
General Mode Tagged VLANs: 10-11 General Mode Forbidden VLANs: Trunking
Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN Tagging: Disabled Trunking Mode VLANs Enabled: All
Private VLAN Host Association: none Private VLAN Mapping:
Private VLAN Operational Bindings: Default Priority: 0
Protected: Disabled console#
What VLAN will untagged ingress traffic be assigned?
정답:
Question No : 6
Which command enables the read-write network monitoring community string?
정답:
Question No : 7
What is a valid subnet mask?
정답:
Question No : 8
What criteria is used to determine STP root elections?
정답:
Question No : 9
Which command shows active telnet sessions on Dell N-Series switches?
정답:
Question No : 10
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links.
The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?
정답:
Question No : 11
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?
정답:
Question No : 12
Which of the following is an IPv4 address?
정답:
Question No : 13
What action needs to be performed to enable SSH on a new switch?
정답:
Question No : 14
Which command is used to prevent STP learning on a port that is connected to a server?
정답:
Question No : 15
In IPv6 addressing, what refers to four binary characters?
