당신은 온라인 연습 문제를 통해 HP HPE0-V14 시험지식에 대해 자신이 어떻게 알고 있는지 파악한 후 시험 참가 신청 여부를 결정할 수 있다.
시험을 100% 합격하고 시험 준비 시간을 35% 절약하기를 바라며 HPE0-V14 덤프 (최신 실제 시험 문제)를 사용 선택하여 현재 최신 60개의 시험 문제와 답을 포함하십시오.
/ 7
Question No : 1
Read the question, and then refer to the exhibit.
<Switch-A>display interface Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: Administratively DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK_SFP_PLUS Unknown-speed mode, unknown-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10, 20 VLAN permitted: 10, 20 Trunk port encapsulation: IEEE 802.1q Port priority: 0 Last link flapping: 0 hours 0 minutes 18 seconds Last clearing of counters: Never Peak input rate: 78 bytes/sec, at 2011-03-31 04:55:57 Peak output rate: 15 bytes/sec, at 2011-03-30 23:00:57 Last 300 second input: 0 packets/sec 67 bytes/sec - % Last 300 second output: 0 packets/sec 14 bytes/sec - % Input (total): 62670 packets, 8565340 bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input (normal): 62670 packets, - bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input: 0 input errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 frame, - overruns, 0 aborts C ignored, - parity errors Output (total): 3707 packets, 1294835 bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output (normal): 3707 packets, - bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output: 0 output errors, - underruns, - buffer failures 0 aborts, 0 deferred, 0 collisions, 0 late collisions 0 lost carrier, - no carrier
A customer added a new switch to their network. They connected it using interface Ten-GigabitEthernet 1/0/1. They are using VLAN 10 and 20 for the devices in their network.
The new switch was fully operational. Then, the customer experienced a power failure later that day and could not reach any device on the new switch after the power returned.
From the output in the exhibit, would could be the issue?
Which HPE MSA storage feature enables tuning the tier-migration algorithm for a virtual volume when creating or modifying the volume?
정답:
Question No : 3
A customer’s environment includes virtual machines and containers. They need an on-premises platform that allows them to easily and efficiently deploy cloud-native applications at rack-scale.
Which HPE solution meets the customer requirements?
A customer is planning to deploy a new Top of Rack solution.
They plan to use a stacking technology that meets the following requirements:
✑ Support for Multi Chassis Link Aggregation in an active-active mode.
✑ The control plane must not be a single point of failure.
✑ Rapid Fail-over. Unified Management.
✑ They require a maximum of two switches per stack.
Which stacking technology meets the customer’s requirements?
DRAG DROP
A customer is considering an upgrade of their networking infrastructure with HPE FlexFabric 5940 series switch.
Match the fan tray option with the airflow direction.
A customer needs to integrate a new digital video surveillance solution into their existing environment and available network ports. The solution needs to include redundant hypervisor servers and a redundant SAN with a shared Fibre Channel attached storage array.
You plan to propose the following configuration:
✑ 2 HPE DL380 Gen10 servers with dual processors, 384 GB of memory, dual port 10 Gb NIC, and High Performance Fan Kit
✑ 1 HPE MSA 2050 Dual Controller Storage Array with 24x 1.8 TB 10 K SAS drives and 96x 7.2K NL drives
✑ 4 VMware vSphere Standard licenses
✑ 1 VMware vCenter Server Foundation licenses
✑ 5 year 24x7x4 support for all equipment
What must be added to the configuration to provide a complete solution? (Choose two.)
정답:
Question No : 7
A customer requires a management solution that will provide email notifications if hardware errors occur on their servers.
Which management solution provides this functionality?
정답:
Question No : 8
A customer has a single HPE ProLiant Gen 10 server.
Which embedded management tool should they use to monitor the server?
HPE Support asks you to generate an SSD wear gauge report for local storage on an HPE DL360 Gen10 server running VMware.
Which procedure will ensure that the server will boot directly into a maintenance state so you can generate the requested report?
The information shown is displayed for a Nimble array you are installing. The customer’s administrator has asked you for the speed at which the Nimble ports are connecting to their SAN switches, and you have run the command shown to determine the number of gigabits per second used by this port connection.
What speed does the exhibit indicate is in use?
정답:
Question No : 11
Which web service uses baste CRUD operations performed on resources using HTTP Post, Get. Put. Delete, and Patch?
정답:
Question No : 12
Which HPE remote management tool offers simplified warranty and contract case management?
Which feature in a block storage array is effective in decreasing the size of blocks?
정답:
Question No : 14
Which series of internal checks will an HPE ProLiant server use to validate that the base hardware components are working correctly before booting the operating system?
정답:
Question No : 15
Refer to the exhibit.
A customer has two HPE ProLiant DL380 Gen10 servers running as an Oracle cluster. They are trying to reduce licensing costs and want to move to the best processor available from the list to minimize licensing costs while still providing a high level of performance for the Oracle database.
Which DL380 Gen10 processor would you recommend?
